The Ford Barn - View Single Post

BILL WZOREK · 02-13-2014, 02:09 PM

I know that this is on the edge of being car related But with the storm some had in the last few days & we are getting today and tomorrow and..............

I thought I would share a some ideas I came up with.

OK here are a couple things I have found not new but may have gone by wayside in our thought process.

(1) While Drilling I ran out of cutting Oil , so trip to lees sewing room Borrowed / stoled her 3 in 1 oil
I was surprised how well it worked.
I think it cut better then the cutting oil.
I have yet to do a temp check of the bit to see if one or the other helps to
keep the drill running cooler need to get more cutting oil 1st

( 2 ) using 2" soft sanding disks Blue / Red / gray in color ( you know the ones)
I needed to get into some small spots I went to NAPA to see if they had any 1" disks No such animal ~ Back at garage I looked at how many used 2" disk were in the trash then ~ it hit me. Those disks are only worn on the outside edge.~SO ~
While I was taking a break for my back I grabbed a pair of scissors and cut around the plastic backing VWALA { spelling} I had a whole drawer of 1" sanding disks.

Is there any other Helpful Shop / Flathead hints out there ???

02-13-2014, 02:09 PM	#1
BILL WZOREK Senior Member Join Date: May 2010 Location: Florence Ma. Posts: 2,404	Shop Tips ~ 2014 ~ I know that this is on the edge of being car related But with the storm some had in the last few days & we are getting today and tomorrow and.............. I thought I would share a some ideas I came up with. OK here are a couple things I have found not new but may have gone by wayside in our thought process. (1) While Drilling I ran out of cutting Oil , so trip to lees sewing room Borrowed / stoled her 3 in 1 oil I was surprised how well it worked. I think it cut better then the cutting oil. I have yet to do a temp check of the bit to see if one or the other helps to keep the drill running cooler need to get more cutting oil 1st ( 2 ) using 2" soft sanding disks Blue / Red / gray in color ( you know the ones) I needed to get into some small spots I went to NAPA to see if they had any 1" disks No such animal ~ Back at garage I looked at how many used 2" disk were in the trash then ~ it hit me. Those disks are only worn on the outside edge.~SO ~ While I was taking a break for my back I grabbed a pair of scissors and cut around the plastic backing VWALA { spelling} I had a whole drawer of 1" sanding disks. Is there any other Helpful Shop / Flathead hints out there ???