Thread: JB Weld on crank end housing?
View Single Post
Old 01-06-2014, 02:02 AM   #1
Rubatoguy
Member
 
Rubatoguy's Avatar
 
Join Date: Mar 2012
Location: Oregon City
Posts: 47
Default JB Weld on crank end housing?
I pulled the flywheel on my model A engine and found this - It looks like the rebuilder used JB Weld to form half of the end of the crank end bearing housing. Is this done very often and an accepted repair?

Todd
Attached Images
File Type: jpg jbweld at crank end sm.jpg (68.3 KB, 645 views)
Rubatoguy is offline   Reply With Quote