The Ford Barn - View Single Post

Jack E/NJ · 11-12-2013, 01:27 PM

Henry---Once the pulley is off the shaft, you're home-free. The shaft assembly should easily push thru the bushing or bearing .

As for the rust, buy a few gallon jugs of bulk white vinegar at the supermarket. Use it straight. Run it for a few days. Drain. Neutralize with washing soda or baking soda solution. Drain again. Then put 50/50 anti-freeze in it.

Jack E/NJ

11-12-2013, 01:27 PM	#2
Jack E/NJ Senior Member Join Date: May 2010 Posts: 2,259	Re: Best rust solution? Henry---Once the pulley is off the shaft, you're home-free. The shaft assembly should easily push thru the bushing or bearing . As for the rust, buy a few gallon jugs of bulk white vinegar at the supermarket. Use it straight. Run it for a few days. Drain. Neutralize with washing soda or baking soda solution. Drain again. Then put 50/50 anti-freeze in it. Jack E/NJ