Quote:
Originally Posted by jhowes
You must be getting tired of questions but, I have an engine that has sat out like yours how did you free up the pistons etc. No penetration solution seems to touch mine. The pistons are stuck and who knows what else. Jack
|
In my case I was going to bore the cylinders any way. So I just busted the pistons out. The cylinder walls were pitted bad. Took 3/16 of a inch to clean them up.
If your engine is not to bad, use some kind of penetrating oil in the cylinders. In the past I made a tool out of a old starter, put a nut on the shaft, bolted in place of the starter. Then turned it with a big wrench. That broke it loose.