The Ford Barn - View Single Post

'29wagon · 08-28-2010, 12:13 AM

measure your head, gasket, nut and washer, then add another quarter inch. form what I know, at least two threads should be visible above a tightened nut . then torque it. the stud will stretch and you will need to torque it again after running up the temperature.
follow the correct sequence .

08-28-2010, 12:13 AM	#14
'29wagon Senior Member Join Date: May 2010 Location: H.B. California Posts: 451	Re: Head / Stud Removal measure your head, gasket, nut and washer, then add another quarter inch. form what I know, at least two threads should be visible above a tightened nut . then torque it. the stud will stretch and you will need to torque it again after running up the temperature. follow the correct sequence .