Quote:
Originally Posted by Joe K
That seems a reasonable way to close a hole from the inside. As the man says some solder on the outside and one would never know there had been a repair (without looking inside.)
Still, the baffling. Somewhere on the 'net is a pix or diagram of the internal baffling. Perhaps given a pix the man can tell us more (or learn from the diagram) on the best way to accomplish this?
Just keeping an open dialogue here...
He obviously has an interest to do the job right. This is where one STARTS on getting a successful restoration done.
Joe K
|
Ummm, like the picture I posted above showing the baffles?
