01-05-2013, 12:01 AM
|
#9
|
Senior Member
Join Date: May 2010
Posts: 3,099
|
Re: Oil Pan fit?
Quote:
Originally Posted by George, Iowa
My 3/8 inch drive will not come close to the bolt. I think MAG is on to something. My front cross member has been replaced. It must be a thicker cross member.
|
How does your hood fit? Your pic is too small to be certain of any details but it appeared to me to be a ribbed cross member meaning it's a '28 cross member. These had different rivet hole spacing than the later cross members. If the wrong reference hole was used then it may be out of position.
|
|
|