The Ford Barn - View Single Post

wrndln · 10-27-2012, 07:21 PM

Steve,
I see what you mean. It looks very close to the third version, except for the lack of a curved up area in the lower left side. Maybe there were several venders that made the assemblies and they took a little liberty with the design. I will check my 5 or 6 version three assemblies and see if any look like the one in your picture. I suppose the people that wrote the JG's will add one more assembly to the guidelines - ha ha. The plot thickens!!

I was hoping some Fordbarner that had a car made between June 28 and Sept 28 that was not molested would respond on what throttle assembly was on their car.
Rusty Nelson

10-27-2012, 07:21 PM	#12
wrndln Senior Member Join Date: May 2010 Location: Lakeville, MN Posts: 5,175	Re: Second version of the throttle assembly Steve, I see what you mean. It looks very close to the third version, except for the lack of a curved up area in the lower left side. Maybe there were several venders that made the assemblies and they took a little liberty with the design. I will check my 5 or 6 version three assemblies and see if any look like the one in your picture. I suppose the people that wrote the JG's will add one more assembly to the guidelines - ha ha. The plot thickens!! I was hoping some Fordbarner that had a car made between June 28 and Sept 28 that was not molested would respond on what throttle assembly was on their car. Rusty Nelson