09-29-2012, 04:01 AM
|
#43
|
|
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: Cleaning oil pan sludge without dropping it- before changing to detergent based o
Quote:
Originally Posted by Chris H
When I pulled my oil pan, I expected the worst when reinstalling the pan and new gaskets. I had the car on jack stands and used a small bottle jack to support the pan, just to hold it in place. I applied a very very light coat of silicone gasket sealant to the engine side of the gaskets to hold them to the block. Made sure the gasket surfaces were clean and free of oil, dirt, and grease. Then just raised the pan in place and adjusted the bottle jack to hold the pan in place while installing the bolts. It was very easy and took about an hour.
I thought it was too easy, and expected to see some leaks. So far so good after about 500 miles or so. I park it over a pan and never see any oil.
Maybe it was beginners luck ???  |
Naw! Chris, It ain't beginner's luck,
Chief would say, "IT'S SUPER SKILL!"
Keep on wrenchin' Bill W.
__________________
"THE ASSISTANT GURU OF STUFF"
|
|
|