Quote:
Originally Posted by Tom Wesenberg
I grease the center section of the spring to help it slip into place and to make it easier to slide side to side to find the center hole.
|
Thanks Tom, I made sure to give the U JOINT good grease and had the spring greased as well.
If I understand correctly the drive shaft cone only runs half way up on the inner plate and not fully right up to the back of the tranny right? Then the two clam shells clamp all the way around? I"m just making sure the U JOINT and drive shaft are all the way in and I can see were it use to sit on the inner plate but just want to be sure.