07-01-2010, 08:45 PM
|
#9
|
Senior Member
Join Date: May 2010
Posts: 3,099
|
Re: Frame rivets revisited
Quote:
Originally Posted by California Charlie
I do have another question. It appears the process goes better with the heated rivets. I know some are also supposed to be installed cold. Would there be an issue with installing them all hot?? Just curious. CC
|
Ok, I'm confused. I think there may be a terminology issue going on here. The first pic is the frame:
The frame is riveted primarily 1/4" rivets with a few 5/16" rivets for the running board brackets. These are done hot and have holes a bit over sized that must be filled by the rivet.
By contrast, body assemblies as shown below use 3/16" rivets which are done cold. The holes ARE NOT any larger than needed to slip the rivet in. The waffle setting tool is used in every case I can think of including the floor assembly.
|
|
|