Sponsored Links (Register now to hide all advertisements)
Drilled center of heads out with a drill press and finished with a punch. Installed like Jim did. Right tool on link wrong size I ended up using a 3/16 inch and worked fine. Rivet end is 1/4" but found not enough material to fill the tool cavity of a 1/4" tool & draw rivet tight. Had to Finish with a ball peen hammer. Get a beehive spring from NAPA or other auto house for your air gun to hold the tool. If you're not in a hurry check aircraft tool houses online for tool & Spring less expensive since they're not specialty tools for them. Tim