The Ford Barn - View Single Post

Brentwood Bob · 07-18-2025, 06:30 PM

When replacing the floor boards I put threadstock in each clinch nut in the subframe. The top of the threadstock was ground to a sharp point. This located the hole to drill. Went one at a time.

07-18-2025, 06:30 PM	#23
Brentwood Bob Senior Member Join Date: May 2010 Location: brentwood, ca Posts: 4,420	Re: Floorboard When replacing the floor boards I put threadstock in each clinch nut in the subframe. The top of the threadstock was ground to a sharp point. This located the hole to drill. Went one at a time.