Quote:
Originally Posted by 40cpe
There is no continuity between the switch terminal and ground. Can I assume that the valve is distributing pressure to front and rear circuits?
|
assume = a$$-u-me
Without the lamp, it may prove difficult to determine the pintle having moved. Possibly using a test lamp.
The procedure to center the pintle (once tripped) usually requires the use of the warning lamp.
The fitting (tool) I am describing does not allow the pintle to move.
If any of this is not clear, yell at me. I am not proud.
See if the attached shows large enough to cipher -
__________________
*****
"Last Sunday, I caught him makin' eyes at Idell Bushey durin' preachin'. And I know what they do up there in the hills when they say they're possum huntin'. They're just sittin' around the campfire, drinkin' hard cider, hittin' each other on the shoulder and hollerin' 'flinch!'."
― Charlene Darling (Daughter of Briscoe Darling)