Quote:
Originally Posted by AL in NY
After both my engine pans had the front ears broken off from engine vibration, I decided to soft mount my new pans on the engine side using two fender washers and two 1/8 inch thick rubber washers. This washer-rubber-pan-rubber-washer stack at the pan mounting points has cut down engine to frame vibration and hopefully extended the life of my engine pans. Been working for three years now.
|
I was going to say that adding a rubber washer should help on vibration some. I remember another thread here about attaching the pans and som one tapped the holes on the frame and could just screw in bolts from underneath while you’re already there, no need for third hand. You can always use nut and bolt even with this method if it’s a points car. I plan on doing this myself.