Quote:
Originally Posted by NealinCA
That's a 32-34 spindle, so no seal in the hub, just the tin grease shield on the spindle.
I'd recommend getting one of these bearing packers
https://www.summitracing.com/parts/l...iABEgIKf_D_BwE
You just fill it with grease, set your bearing in and push down until you see grease come through the bearing rollers. You can do the same in the palm of your hand, but this is a little cleaner and takes some of the guess work out. |
Thanks for the info.
Yes, these are ‘32 spindles.
I was able to clean them up and the bearings now slide on.
I will be sure to thoroughly clean everything before assembly. They still need paint and I am pretty meticulous about prep.
So the seals are the cups built into the spindles?
Unfortunately, I just have a pile of hodgepodge parts and wasn’t able to disassemble everything to see how it is supposed to be.
I will remove the races from the drum and press in the new ones. Any tips on that?