Quote:
Originally Posted by luke72
Hi guys i need help , i have a banjo rear axle and a millworks model T spring in model A rear frame and cross member , now the question how much should be the space between the top axle and frame, because with this spring is very low less than a inch thanks
|
Can you post a picture? I'm assuming you are talking about the spring end. Is the main leaf reversed as well?
With stock shackles, you should be OK. You can check it by pressing down on the spring and watch it go through it's arc. If it doesn't hit, it's fine. If it does, then you need to figure something else out. You don't want it hit the top of the axle bell when it's fully compressed.