Re: Wrist pins
Also remember that the pin fit is very close tolerance,even holding it your hand for a few minutes can warm it up enough to increase it's diameter enough to cause a tight fit it your in a cold or cool shop.
Not your problem here but soming to remember
I assume the pins came with the new pistons and there fit should be good.
So fitting the pistons ok I would take the pins and rods to a machine shop and have them honed to fit the pins and you should be good to go
Simple job that only takes a few minutes to do.
Maybe take a piston and have them double check it's fit with the pins as well.
|