The Ford Barn - View Single Post

glennpm · 04-25-2025, 01:41 PM

I have a '32 with a 59AB engine. My front pulley seal surface was worn so I bought a new pulley from Kiwi and built this wood jacking tool to raise the engine. I had done this in the past on my'40 with a SBC so I knew what I needed.

Glenn

04-25-2025, 01:41 PM	#3
glennpm Senior Member Join Date: Sep 2014 Location: Mid-Coast Maine Posts: 2,815	Re: Motor mounts change I have a '32 with a 59AB engine. My front pulley seal surface was worn so I bought a new pulley from Kiwi and built this wood jacking tool to raise the engine. I had done this in the past on my'40 with a SBC so I knew what I needed. Glenn __________________ Archives of historical but relevant older articles: ------------- Hover mouse over the links below and click! ~~~~~~~~~~~~~~~~~--------------- Rumble Seat's Notes Techno-Source-for-the-1932-thru-1953-Flathead-Ford