The Ford Barn - View Single Post

glennpm · 04-15-2025, 03:16 PM

I got a push rod with the master cylinder. There is a clip ring to take off. I then figured what I needed for length and welded on a threaded end to a cut off rod. As you can see it is well retained.

Glenn

04-15-2025, 03:16 PM	#84
glennpm Senior Member Join Date: Sep 2014 Location: Mid-Coast Maine Posts: 2,815	Re: What Master Cylinder I got a push rod with the master cylinder. There is a clip ring to take off. I then figured what I needed for length and welded on a threaded end to a cut off rod. As you can see it is well retained. Glenn __________________ Archives of historical but relevant older articles: ------------- Hover mouse over the links below and click! ~~~~~~~~~~~~~~~~~--------------- Rumble Seat's Notes Techno-Source-for-the-1932-thru-1953-Flathead-Ford