Quote:
Originally Posted by Y-Blockhead
The vendors sell those two shafts with the groove already cut into them
|
At that time (20 years ago?) the grooved shafts were not available - and its a logical extension and I considered it far better (likely tighter) than the cover/gasket.
In this case it appears the hole has worn. There is nothing to keep the cluster shaft from turning other than the friction in it's hole. Some rebuilder instructions look to have the shaft "tight" in the hole - so tight it won't drop of its own weight when you hold up the case. Tightening the hole IS probably the best initial solution. I would go on to a positive seal since that's the part that Henry obviously left out.
Joe K