The Ford Barn - View Single Post

Joe K · 03-02-2025, 05:07 PM

Glyptol would be my choice.

Red, somewhat heavy coating impervious to oil, water, gasoline. Applied as a spray (thinner and more precise coating) or with a brush (heavier.)

You'll want to mask well those areas you don't want to gamble to "plug."

Used a lot on cast machine cases to prevent ingrained foundry sand from coming loose and getting into the moving parts.

A bit expensive. About $55 for either 12oz spray can or 32oz brush on.

Quality though...

Joe K

03-02-2025, 05:07 PM	#4
Joe K Senior Member Join Date: Jul 2010 Location: Cow Hampshire Posts: 4,610	Re: carb rust Glyptol would be my choice. Red, somewhat heavy coating impervious to oil, water, gasoline. Applied as a spray (thinner and more precise coating) or with a brush (heavier.) You'll want to mask well those areas you don't want to gamble to "plug." Used a lot on cast machine cases to prevent ingrained foundry sand from coming loose and getting into the moving parts. A bit expensive. About $55 for either 12oz spray can or 32oz brush on. Quality though... Joe K __________________ Shudda kept the horse.