The Ford Barn - View Single Post - Windshield-Rear window trim

flathead48 · 02-05-2025, 05:22 PM

If the rubber seal has the groove for the trim, u are good to go , gently push each side in until they just come together in the middle . The center strip holds it all together. The rear is same deal if the groove is there. Slide it in until the two ends come together at the bottom, small clip holds them securely. Note, I never saw a Ford with that SS trim it was used on Mercurys. So if your rubber doesn’t have the groove u will have to replace it with one for Mercury. Hope this helps.

02-05-2025, 05:22 PM	#2
flathead48 Senior Member Join Date: May 2010 Location: Saratoga Springs, NY Posts: 1,235	Re: Windshield-Rear window trim If the rubber seal has the groove for the trim, u are good to go , gently push each side in until they just come together in the middle . The center strip holds it all together. The rear is same deal if the groove is there. Slide it in until the two ends come together at the bottom, small clip holds them securely. Note, I never saw a Ford with that SS trim it was used on Mercurys. So if your rubber doesn’t have the groove u will have to replace it with one for Mercury. Hope this helps.