The Ford Barn - View Single Post - Any one have a tried and true method for this one

Flathead Fever · 01-20-2025, 11:08 PM

We took broken bolts out of engines at work by welding a nut to them. I probably did this at least twenty times over 30-years and I never screwed anything up. That one should be easy to weld a nut to it as longs it's a steel plug and not brass one.

Be careful you don't break the corner of that casting off.

01-20-2025, 11:08 PM	#18
Flathead Fever Senior Member Join Date: May 2010 Location: Yucaipa, CA Posts: 1,359	Re: Any one have a tried and true method for this one We took broken bolts out of engines at work by welding a nut to them. I probably did this at least twenty times over 30-years and I never screwed anything up. That one should be easy to weld a nut to it as longs it's a steel plug and not brass one. Be careful you don't break the corner of that casting off.