The Ford Barn - View Single Post - Any one have a tried and true method for this one

Mart · 01-20-2025, 04:12 PM

You could try hammering in a suitably sized torx bit.

Personally if a pipe wrench couldn't do it I would be tempted to weld something to it. A piece of scrap metal bar or a big nut.

01-20-2025, 04:12 PM	#10
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 9,083	Re: Any one have a tried and true method for this one You could try hammering in a suitably sized torx bit. Personally if a pipe wrench couldn't do it I would be tempted to weld something to it. A piece of scrap metal bar or a big nut.