The Ford Barn - View Single Post

Bored&Stroked · 01-16-2025, 11:53 AM

What are you guys seeing as far as the quality of the seat finish and concentricity? Anybody use a seat mic afterwards to see if there is any run-out?

I'm used to stones where you have a really nice concentric and almost polished seat. I'd love to see some close-up pictures if any of you have them. I might be able to use my Kwik-Way Seat cutting setup with one of these Neway cutters to do the seat work (depending on the quality of the finish and concentricity).

01-16-2025, 11:53 AM	#8
Bored&Stroked Senior Member Join Date: Jan 2011 Location: Central Ohio Posts: 5,723	Re: Valve seat cutter and proper pilot What are you guys seeing as far as the quality of the seat finish and concentricity? Anybody use a seat mic afterwards to see if there is any run-out? I'm used to stones where you have a really nice concentric and almost polished seat. I'd love to see some close-up pictures if any of you have them. I might be able to use my Kwik-Way Seat cutting setup with one of these Neway cutters to do the seat work (depending on the quality of the finish and concentricity).