The Ford Barn - View Single Post - Connecting rod machined to take insert bearing ?

headonz · 10-30-2024, 01:09 AM

I am still a little confused on this issue.
Can the standard B motor connecting rods be machined to take the insert bearings from Snyder ect.

Most topics in the past seem to result in the babbit vs insert debate

10-30-2024, 01:09 AM	#1
headonz Member Join Date: Aug 2024 Location: Motueka New Zealand Posts: 49	Connecting rod machined to take insert bearing ? I am still a little confused on this issue. Can the standard B motor connecting rods be machined to take the insert bearings from Snyder ect. Most topics in the past seem to result in the babbit vs insert debate