The Ford Barn - View Single Post - Wishbone radius rod bushing (rubber ball))

koates · 07-22-2024, 08:49 PM

Start up your air compressor and run out the air hose with a nozzle on the end. With the left hand begin to push the rubber ball onto the wishbone ball. Put the air nozzle into the little hole in the rubber ball and give it a squirt or two of air and the rubber will jump on the ball. Doubtful you will need any lube on it. I have done it this way for over 50 years. Regards, Kevin.

07-22-2024, 08:49 PM	#4
koates Senior Member Join Date: May 2010 Location: Melbourne Australia. Posts: 2,185	Re: Wishbone radius rod bushing (rubber ball)) Start up your air compressor and run out the air hose with a nozzle on the end. With the left hand begin to push the rubber ball onto the wishbone ball. Put the air nozzle into the little hole in the rubber ball and give it a squirt or two of air and the rubber will jump on the ball. Doubtful you will need any lube on it. I have done it this way for over 50 years. Regards, Kevin.