[Bob Bidonde]

nkaminar, I used 2 floor jacks to install the Aries. One jack on the front axle to get the car up on a block so I could fit under the running board, and a second jack to raise the front pipe of the Aries into the exhaust manifold.
I must say that the Aries muffler is the first one I installed that I did not have to reform clamp flange as shown in the slide.
The test drive was successful, no leakage and no ticking noise. I sense that the Aries muffler has given my engine some added power. Throttle response seemed better than usual.