Re: Crimp Wiring Tool
I like the soldering technique by JW, Post #8. I also like the idea of putting a slug of solder in the connector before heating as Hitman suggested in Post #11. I think if you are careful and don't use a lot of solder, you can minimize the risk of fracture by bending over time. The heat shrink tubing that Y-Blockhead talked about in Post #13 is also a good idea and will act as a strain relief.
__________________
A is for apple, green as the sky.
Step on the gas, for tomorrow I die.
Forget the brakes, they really don't work.
The clutch always sticks, and starts with a jerk.
My car grows red hair, and flies through the air.
Driving's a blast, a blast from the past.
|