Quote:
Originally Posted by BRENT in 10-uh-C
Thinking about a couple of points to your theory;
A) We are assuming that the Nu-Rex Wrench was indeed brand new and actually defective.
B) It has the look to me as if the tang was sheared-off due to excessive force from someone who did not know what they were doing.
I suspect the wrench was used based on the shiny-ness (-or lack thereof) of it, so it could have been damaged before he received it. If it was indeed brand new, why not just call Nu-Rex directly and send a picture describing what was wrong. If it truly was new and defective, logic would suggest they would have sent a replacement immediately. At that point, the topic likely would have been much different.
|
Concur that the tang definitely looks to have been partially sheared off/smaller than it should be - but my assessment (defective wrench) is based on the position of the tang itself - on a "good" wrench (i.e. based on the photo from Nu-Rex's website), the tang appears to be around the 4:30 o'clock positon, whereas the youtuber's wrench has a (much smaller) tang around the 1:30 o'clock position, 90 degrees off.