Quote:
Originally Posted by wbs
hello my car could not be all original the bottom steering wheel to seat is only 6" the distance fr upper front edge of seat is 26" to a depressed clutch pedal. i put the seat platform[ called riser?] where prior holes were found. does the 6" seem too short and the 26" seem too long to you?
if so what modification should i make to correct? i made a side view sketch and attached it below
|
Can you post a few pictures? The 26" measurement from the floorboard is about right, but when I see the 4" measurement from the top of cushion to the bottom of the steering wheel, that tells me the seat cover was installed incorrectly. Again, pictures will give me a visual where I can confirm. Also, if the cushion was overstuffed, then likely the backrest was done likewise which can severely cramp your cabin space.