Quote:
Originally Posted by Bob Bidonde
While researching the 1932 - 1937 Ford Service Bulletins, I stumbled upon information regarding the tightening torque for the Model "A's" pinion bearing jam nut. The final torque is little more than hand tight:
- January - February 1934 Bulletin states, "The correct torque for the stub mounted pinion, as used in the Models A, B and early 18 is from 35 to 47 Inch-lbs."
- August 1934 Bulletin states, "The passenger drive pinion bearing adjustment has been reduced five inch-lbs. Correct adjustment for the various axles is as follows: Model 40 12 to 17 Inch Pounds; Model18 Straddle Pinion 12 to 17 Inch Pounds; Model B-18 Stub Pinion 15 to 20 Inch Pounds; Model A 15 to 20 Inch Pounds; Model AA Timken Type 12 to 16 Inch Pounds; Model BB 3/4 Floating 12 to 16; Model BB Full Floating 12 to 16 Inch Pounds.
No reasons were given for the reductions in torque. |
Bob, would it be possible for you to post scans of those pages here so that we can read the entire procedure in context?
It is not clear to me where the in-lbs of torque you are quoting are to be applied. If there are some drawings in the Bulletins that show this, it may help. Thanks!