The Ford Barn - View Single Post

Bored&Stroked · 03-25-2024, 04:32 PM

You'll probably find that you'll need to ream or hone the IDs of those once they're installed. You can use a basic brake cylinder hone to get the job done.

I made a pilot on my lathe - that picks up the ID as well. These split bushings like to collapse and then the ends will overlap . . . then you start all over again!

03-25-2024, 04:32 PM	#4
Bored&Stroked Senior Member Join Date: Jan 2011 Location: Central Ohio Posts: 5,202	Re: Clutch Release Shaft Bushing tool You'll probably find that you'll need to ream or hone the IDs of those once they're installed. You can use a basic brake cylinder hone to get the job done. I made a pilot on my lathe - that picks up the ID as well. These split bushings like to collapse and then the ends will overlap . . . then you start all over again!