Thread: pinion gear double cup bearing issue
View Single Post
Old 02-24-2024, 10:58 AM   #3
Tom Endy
Senior Member
 
Tom Endy's Avatar
 
Join Date: May 2010
Location: Southern California
Posts: 3,168
Default Re: pinion gear double cup bearing issue
Quote:
Originally Posted by duke36 View Post
How does one using an inch pound wrench get an accurate reading on the end of the driveshaft ?
A 1&1\16" six-point, deep socket will slide over the splines on the end of the drive shaft.

Tom Endy
Tom Endy is offline   Reply With Quote