Re: 34 pickup floor board/toe board/trans cover fasteners?
The #2 floorboard (made of plywood) is attached to the fore and after and cross sills will 1/4 - 20 flat head countersunk machine screws with 1/4" countersunk washers, both with an S-2 (black oxide) finish as was the #1 floorboard.
The transmission cover was attached to the #2 floorboard with short #14 countersunk wood screws and 1/4' countersunk washers.
The pedal/column seal fits between the #1 steel floorboard and the stamped steel separate cover.
A taupe rubber mat covered the #1 and #2 floorboards.
|