Quote:
Originally Posted by Marshall V. Daut
I followed Larry's recommendations for head gasket and always used the 7013 with copper adhesive spray on both sides. I think he was recommending the 7013C gasket towards the end of his manufacturing days, as I recall. If you follow Larry's instructions on your resurfaced block and check the head to be sure it is not too far out of spec, you should be o.k. with the new studs and nuts. Just keep re-torquing the head until you are sick to death of doing it. THEN the head should be seated.
M.
|
Awesome information! Thanks everyone for your responses.