The Ford Barn - View Single Post

CT Jack · 12-09-2023, 10:01 AM

I agree with suggestions made regarding a good ground to both the frame and engine casting. With the battery fully charged and lights off adjust the 3rd brush until ammeter indicates 0 at idle. I would replace all the lamps with 6v LED's then the maximum load would only occur when using the starter or the horn.

12-09-2023, 10:01 AM	#5
CT Jack Senior Member Join Date: May 2010 Location: Hebron, CT Posts: 537	Re: Powerhouse Genny Charge/Discharge I agree with suggestions made regarding a good ground to both the frame and engine casting. With the battery fully charged and lights off adjust the 3rd brush until ammeter indicates 0 at idle. I would replace all the lamps with 6v LED's then the maximum load would only occur when using the starter or the horn.