Re: Woven vs molded linings for cast iron drums
I just tig welded one of my rears today. Have yet to mill it down but I cannot imagine favorable results from bending the tabs up creating non horizontal tabs. I have relatively little experience but of the brakes I've disassembled, they have all been found in "that oughta work" condition.
It's no wonder there is so much support for hydraulic brakes, floaters, etc. - anything to go from where we are rather than backing up to where we should have been and correcting decades of blissful neglect. These are nearly 100 year old cars!
Now I just need to figure out the measurements to know how much to remove. Had the red book but it's long gone.
D
|