Quote:
Originally Posted by V8COOPMAN
If Gary ("Krylon32") does not, or is not able to supply you with new, proper-length studs, you can get the proper studs from Dorman. To utilize the "MT Products" drums, you'll need to cut the swage holding each original wheel stud into the stock drum/hub assembly using a 5/8" hole saw. You'll ream the five holes to 0.600" in the hubs and replace with specific Dorman #610-234 studs.
Coop
.
|
Haha, I didn't see your post. I believe Boiling Bros. sells the correct studs, but don't get them from them. Get them from Rock Auto. They are like 3/4's less in price than anyone else.
It took me a few hours going through the Dorman catalog to find the correct ones. Glad Coop posted the correct part number.