The Ford Barn - View Single Post

Krylon32 · 04-22-2023, 08:20 PM

I have had several intakes built by Baxter Ford Parts in Lawrence KS. On the last which was an Offenhauser super dual for the 49-53 motor he uses the apporpriate sized grommet fitted into the road draft tube hole with a PCV valve with a threaded fitting to which he added a hard line back to the side of the intake which he tapped for the other end of the hard line. He's done several of these for me and they have worked great.

04-22-2023, 08:20 PM	#8
Krylon32 Senior Member Join Date: May 2010 Posts: 5,170	Re: Flat Head V8 PCV valve question for you? I have had several intakes built by Baxter Ford Parts in Lawrence KS. On the last which was an Offenhauser super dual for the 49-53 motor he uses the apporpriate sized grommet fitted into the road draft tube hole with a PCV valve with a threaded fitting to which he added a hard line back to the side of the intake which he tapped for the other end of the hard line. He's done several of these for me and they have worked great.