Re: Distributor outer cap gaskets on dome distributors
Quote:
Originally Posted by Brian
No need to cut /trim anything. The gasket fits on the spigot on the outside edge of the inner cap, the outer cap goes on the other side of the gasket; the protrusion in middle of outer cap fits through the hole in centre of inner cap and a rubber o ring is inserted onto the groove on that protrusion, which holds the whole assembly together.
|
I think I follow you, HOWEVER, that leaves a gap between the body and the outer cap for water etc to enter, and it LOOKS VERY WEIRD to boot. I can't imagine Henry's engineers designing something that way.
Can you elucidate ?
__________________
Life is like a roll of toilet paper. The closer to the end, the faster it goes.
It is better to be seen, than viewed.
"We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm".
|