Thread
:
Removing center crossmember
View Single Post
12-29-2022, 05:46 AM
#
7
Oldbluoval
Senior Member
Join Date: Jun 2015
Location: Signal Mtn, TN (SE TN)
Posts: 2,384
Re: Removing center crossmember
I always use a ball shaped burr on my die grinder to put an indentation on the top and then center punch. That die grinder can remove a lot of material before going to the drill bit.
Roto is spot on
Oldbluoval
View Public Profile
Send a private message to Oldbluoval
Find More Posts by Oldbluoval