Re: Big Truck 2 Speed Rear Axle Parts
Quote:
Originally Posted by 38 coupe
At this point I doubt anyone has made a new vacuum can for those axles in decades. See if you can find a spare old one, and carefully take it apart at the crimp. Then see if you can figure out a new diaphragm. You don't have much to lose.
FYI, the two speed is almost guaranteed to be an Eaton 1350 and was used by almost all the truck manufacturers. Spare parts for the axle itself are probably not specific to Ford. The rear brakes, hubs, etc. will probably be Ford specific.
|
I have a can for you if you want it. I could get a pic tomorrow. Been tripping over too many piles lately. Send a PM
__________________
Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1946 Tonner Pickup with 226 H six, 1979 Toyota landcruiser wagon, now wearing 1947 Ford Jailbar sheet metal. 'Rusty ol' floorboards, hot on their feet' (Alan Jackson)
|