Quote:
Originally Posted by ModelAArmy
Thanks for this info. I first want to inspect hinges for problem. In the instructions it said to check this hinge gap.
Straighten door hinges. Door hinges are often bent. Straighten and adjust to obtain an even gap at each hinge pillar measuring 1/16′′ to 3/32′′. No other course of action will resolve this problem.
How and where exactly is this gap measured. Thanks
|
The gap is between the front of the door to the cowl / windshield pillar.
I have found less bent hinges vs worn top hinge pins. The holes are worn out letting the rear of the door sag. They make oversized pins to correct this. You might want to take the rear of the door with it slightly open and raise the latch end up and down. How much movement is there?
Regards
Bill