[KULTULZ]

!!! BINGO !!!

it appears that you had a difficult time finding the right tape and installing it because of access. Are you sure you have the tdc mark on the tape matched with tdc on the dampener? It would be easy to do if you have a lot of stuff in the way. That would explain the lack of advance.

I went back through the posts and didn't find if you confirmed that the tdc mark on the dampener matched tdc of #1 piston by using either a piston stop or check #1 piston valve rock over. It could be that the pulley portion slipped out of position. It happens occasionally.

We have a winner! Cupie doll please ...