The Ford Barn - View Single Post

Brian · 08-24-2022, 02:17 PM

I cannot answer your question, but what I've done in the past in this situation, is I've built up the thrust faces on the bearing with babbit and machined to suit.

08-24-2022, 02:17 PM	#2
Brian Senior Member Join Date: May 2010 Location: Masterton, New Zealand Posts: 3,859	Re: Excessive crank end float. I cannot answer your question, but what I've done in the past in this situation, is I've built up the thrust faces on the bearing with babbit and machined to suit. __________________ Unfortunately, two half wits don't make a whole wit! Last edited by Brian; 08-24-2022 at 10:40 PM.