Re: overtight axle nuts
I recently had a hard nut with a burr in the thread. It destroyed the thread on the axle and I was NOT happy. I took the damaged axle to a machinist friend who cut a new one at 9/16" (same thread pitch) in his lathe. A new nut tightened to about 75 ftlb and I'm back on the road. I suggest you (OP) do similar.
__________________
I'm part of the only ever generation with an analogue childhood and a digital adulthood.
Last edited by Synchro909; 08-08-2022 at 06:04 AM.
|