[jeepguy1948]

Over on the HAMB there is a guy selling "A Corvair disc brake set up off of a 34 Ford. For the money he's asking $200 it could be a good deal for me. I'm concerned about what would be required to install it on a Model A. He is including the spindles which I think will go on a Model A axle, yes, no, maybe? He also mentions S10 but I'm not sure what is Corvair and what is S10. I would need to use an adapter from 5 x 4.75 to 5 x 5.5 to use my '35 wires and a support ring as well. Good deal? Bad deal? Buy it? Run away? It is the dang 5x5.5 lug pattern is what makes this project difficult. There are plenty of pieces available that use the smaller patterns. It probably would not be possible to drill the 4.75 rotors to change it to 5.5? Thanks again. Don