Quote:
|
... the choke lever in my carb's choke housing has no slot in it (unlike most I've seen, which have a slot.) I.e., it needs a choke element/spring that encircles the lever to move it rather than fits in the slot. The one in the kit they sent was for slotted levers. So that was three strikes against that kit, so I said forget it.
|
I'm sorry to hear that.
I
think what is going on as evidenced by the bent levers is that someone previously tried a flat rate repair and caused more damage than good.
Below is a choke cap that
should-may fit your housing. It is difficult to ID hard parts without the CARB ID NO.
My thought is that you need a complete choke housing assy.